Old thread but worth adding. Drain old coolant. Fill and empty twice with clean water to flush old coolant. Add 2.5 litres of neat concentrate. Top up with water. If you use premix, water trapped in the system will cause a weak mixture in the engine. Run engine with heater hose bleed screw open to clear bubbles. Close the bleed screw.
I have recently got a fiat grande punto 2009 plate 1.4 16v and was changing the pads the other day and noticed that there was some gear oil leaking from the square plate that goes around the inner cv joint. I've had a research and I believe there is a seal behind this plate however i did notice there is a layer of silicone around the plate so
13. Oct 15, 2013. #4. last wekend. have cleaned the MAP sensor on a 1.2 8V with 109000k (very easy folowing the forum guides ) it was full of oil, carefuly cleaned with disck brake cleaner spray. have disconected the batery for 1 hour. next day did a 170 km drive on "normal" driving. normaly have a 7.5 lt/100km. Technical When to change oil, Grande Punto. JMaia; Aug 3, 2023; Replies 3 Views 492. Grande Punto. fiatforum @fiatforum. About The FIAT Forum Just replaced the oil and filte ron my 19.Mjet. But how much oild go's into these things? The oil suppliers says 4.2 liters. My fiat booklet index says it's on page 277. But offcours it's an italian manual that ends at 235:( Waiting for an answer now, can't start the engine to go homeHalo, I observed this strange debris in my coolant reservoir. I actually topped up the coolant reservoir using Gabriel coolant I probably added 700 ml of
NkyWVpp.